LED Matrix display driver board for Raspberry Pi RA023
LED Matrix display driver board for Raspberry Pi
RA023
This module allows you to control two 8 x 8 LED matrix displays through SPI communication.
Raspberry Pi Acrylic Case RA025
Raspberry Pi Acrylic Case
RA025
We offer customized any version of Raspberry Pi Acrylic case.
Raspberry Pi LED matrix board compatible with PI Lite RA026
Raspberry Pi LED matrix board compatible with PI Lite
RA026
Introduction:
This product belongs to the module series used on foreign PI-Lite hardware.
1. Compared with the original version, this one has been added LLC (logic level conversion circuit). The serial ports of Raspberry Pi on this end are 3.3V. Single-chip Atmega328 controls 126 LED lights, which are all supplied by 5V power. Protecting the IO interface of PI from the impact of 5V serial port.
2. Single-chip Atmega328 runs stably at 16MHz, which is twice as fast as a 3.3V circuit, helping improve the refreshing rate of the LED.
3. All 126 LED are imported from Taiwan Yiguang and was made by automatic
RaspberryPi GPIO Kit RA027
RaspberryPi GPIO Kit
RA027
GPIO U-type shield for breadboard x 1 GPIO Colorful 40Pin flat Cable x 1
RaspberryPi GPIO Kit RA028
RaspberryPi GPIO Kit
RA028
High quality 400 holes breadboard x 1
GPIO U-type shield for breadboard x 1
GPIO Colorful 40Pin flat Cable x 1
DS3231 Raspberry Pi RTC Board Real Time Clock Module RA029
DS3231 Raspberry Pi RTC Board Real Time Clock Module
RA029
The DS3231 has an internal crystal and a switched bank of tuning capacitors. The temperature of the crystal is continuously monitored, and the capacitors are adjusted to maintain a stable frequency. Other RTC solutions may drift minutes per month, especially in extreme temperature ranges.
TF to SD Card Pinboard for Raspberry Pi RA032
TF to SD Card Pinboard for Raspberry Pi
RA032
Small Size TF to SD Card Pinboard for Raspberry Pi
DIY Prototyping Expansion Board for Raspberry PI RA034
DIY Prototyping Expansion Board for Raspberry PI
RA034
The board adopts the immersion gold process. All the gold plate hole spacing, both for the standard 2.54mm (100ml). Compatible with the DIP IC package is directly welded on the upper end of
the prototype experiment. Extended IO port, can be directly used in bread lines inserted row, convenient use, fast to your creation in the extended edition prototype implementation